Code Alarm CA650 Manual do Utilizador descarregar pdf (Página 7)

Battery Power (12AWG) (RED, 2 wires)

Note: Remove all 30 Amp fuses until all connections are made.

Locate 1 of the vehicle’s constant 12 Volt battery wires at the ignition switch.

Verification: This wire will register voltage in all positions of the ignition switch.

Connect the RED wire to the constant 12 Volt battery wire

IMPORTANT!

If the vehicle is equipped with more than one battery wire at the ignition switch, connect the RED

wires from the 6- pin harness to separate vehicle battery wires.

12 volts Ignition Input/Output (12AWG) (PINK)

Locate the vehicle’s ignition wire at the ignition switch.

Verification: This wire registers voltage when the key is turned to the ON (or RUN) position.

The voltage

does not drop out when the key is turned to the START (or CRANK) position.

Connect the PINK wire to the vehicle’s Ignition wire.

This wire is also used for Ignition 1 Output.

Ignition 2 Output (12AWG) (PINK/WHITE)

Locate the vehicle’s ignition 2 wire at the ignition switch (if equipped).

Verification: This wire registers voltage when the key is turned to the ON (or RUN) position, but not the

ACC (Accessory) position. The voltage does not drop out when the key is turned to the START (or CRANK)

position.

Connect the PINK/WHITE wire to the vehicle’s ignition 2 wire.

Accessory 1 (Heater/AC) Output (12 AWG) (ORANGE)

Locate the vehicle’s accessory wire at the ignition switch.

Verification: This wire registers voltage when the key is turned to the ON (or RUN) position, but not the

ACC (Accessory) position. The voltage drops out when the key is turned to the START (or CRANK) position.

Connect the ORANGE wire to the vehicle’s accessory wire.

1. 6 PIN MAIN POWER HARNESS, CONTINUED

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Sem comentários

Code Alarm CA650 Manual do Utilizador Página 7