Code Alarm CA680 Manual do Utilizador descarregar pdf (Página 17)

2 Pin Override Push-Button Switch: (Blue Connector)

The BLACK and GRAY twin lead wires loaded in the two pin blue connector are the ground supply and

override input of the Remote Start unit. Drill a 1/4" hole and mount this switch in an easily accessible

location under the driver's dashboard.

2 Pin LED Harness: (White Connector)

The RED & BLUE wires loaded into the two pin mini white connector control the anode and cathode of the

dash mounted LED. Drill a 1/4" hole and mount the LED in an easy to see location on the dashboard. Be

careful to check to make sure that there is enough clearance behind the panel you are drilling into.

4 Pin Tracking Port: (Off White Connector)

This 4 pin port is used for connecting the PROPT20 Pursuitrak GPS system.

4 Pin Data Bus Interface Port: (Brown Connector)

This 4 pin port is used for Code Alarm Door Lock and Transponder Databus Interfaces to communicate

with the vehicle's Databus. When using the DBI port to control the Code Alarm Door Lock and Transponder

Interface modules the following options may be available. Please refer to the D2D (Data to Data) function

list available per vehicle on the tech service web site.

Door Trigger Trunk/Hatch Open

Keyless Entry Control Dome Light Supervision

Factory Alarm Arm / Disarm Manual Arm / Disarm Inputs (factory keyless controls system)

4. ACCESSORY CONNECTORS

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Sem comentários

Code Alarm CA680 Manual do Utilizador Página 17