Code Alarm Professional Series CA 4050 Guia de Instalação descarregar pdf (Página 10)

4 BLACK/YELLOW PULSE DURING CRANK ( - )

Locate the vehicle’s second starter (crank) wire at the ignition switch. (if equipped)

Verification: This wire registers voltage only in the start (crank) position of

the ignition switch.

Connect the BLACK/YELLOW wire as shown in the diagram below. Use an SPDT

relay (not supplied).

F us ed +12 Volt

B a tte ry S ourc e

87a

BLACK/YELLOW Pulse

During Crank Wire

To Vehicle's 2nd

S tarter Wire

Jump To PUR PLE

Starter Output

Wire From The

C ontrol Module

2 Pin Lock Output Harness

1 BLUE UNLOCK ( - )

The door unlock output wire provides an output only while the remote start feature

is active.

3 GREEN/WHITE FACTORY ARM /

PULSE AFTER SHUTDOWN ( - )

This wire will supply a ( - ) 500mA pulse both upon arming the system and after

the remote start shuts down. This is typically used to re-lock the vehicle’s doors if

they unlock upon remote start shutdown. It can also be used to pulse a door pin-

switch wire to prevent the vehicle’s accessories from remaining on after remote

start shutdown.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sem comentários

Code Alarm Professional Series CA 4050 Guia de Instalação Página 10