Code Alarm CA 110 Manual do Utilizador Página 1

128-68321 of 16Avoid mounting components orrouting wires near hot surfacesAvoid mounting components orrouting wires near moving partsTape or loom wire

128-68322 of 162INSTALLATION OF THE MAJOR COMPONENTSControl Module:Select a mounting location inside the passenger compartment (behind the dash), and

128-68323 of 163WIRING THE SYSTEMRed: +12 VDC CONSTANT BATTERY SOURCEConnect this wire to a +12 Volt constant source found at the vehicles ignition s

128-68324 of 164Grey: (-) Instant Trigger Zone 2This is an Instant ground trigger wire. It must be connected to the previously installed hood and/ortr

128-68325 of 16Blue & Green 2 Pin White Connector:Door Lock/Unlock OutputsThese wires will provide a pulsed ground output to the factory door lock

128-68326 of 165COMPLETING THE INSTALLATIONAntenna Wire: Be sure to extend the thin black antenna wire to it’s full length, and cable tie into place w

128-68327 of 166Select By Operating Transmitter Press Btn 1 Press Btn 2 Press Btns1&2Siren Indications 1 Chirp 2 Chirps 3 Chirps1) Arming Method P

128-68328 of 167To program these selectable features;Action System ResponseTurn ignition on then back off No responsePress and rele

128-68329 of 16ANTENNAL.E.D.(PLUG-IN)SHOCKSENSORGREENBLUEDOOR UNLOCK OUTPUT (-)DOOR LOCK OUTPUT (-)VALET/OVERRIDESWITCHPINKSWITCHED +12VOLTS IGNITIONV