operations (rated voltage and load)
w Update Time: ½ cycle or 1-second
Solid State Outputs
w 4 Solid State Outputs: D1-D4
w Contacts: Form A
w Maximum voltage: 30 V
w Maximum current: 100 mA
w Isolation: Optically isolated. Max 5000 Vrms
isolation (UL:E64380)
w Scan Time: ½ cycle or 1-second
Power Supply
w Rated Inputs: AC: 85 – 240 VAC (+/-10%),
47-63 Hz DC: 110 – 330 VDC (+/10%)
w Dielectric Withstand:2000 VAC RMS, 60Hz for 1
minute
w Burden: Typical: 10 VA, Max: 20 VA
w Ride-through: Min: 100ms (6 cycles @ 60 Hz @
96 VAC) 200ms (12 cycles @ 60 Hz @ 120 VAC),
800ms (48 cycles @ 60 Hz @ 240 VAC)
Communications
COM 1
w Interface: RS-232E DTE (male DB9 connector) or
RS-485 (captured wire connector)
w Duplex: Full (RS232E), Half (RS485)
w Isolation: Optical
COM 2
w Interface: RS-485 (captured wire connector)
w Duplex: Half
w Isolation: Optical
COM 3
w Interface: IrDA Compliant, or 33.6 kbps internal
modem
w Duplex: Half
w Distance: 0 - 1 meter
w Optical range: +/- 15 degrees (min), +/- 30
degrees (max)
w Location: Front of Meter (IrDA), Com Card
(MODEM)
COM 4 (NETWORK)
w Interface: IEEE 802.3-1993, ISO/IEC 8802-3:1993
(Ethernet) 10Base-T or 10Base-FL (optional)
w Cabling: 10Base-T Unshielded twisted-pair cable,
0.5 mm (24 AWG). Max. length: 100 meters
10Base-FL Fiber optic cable, 62.5/125 um
nominal, wavelength: 820 nm Max. length: 2000
meters
w Connectors: RJ45 10Base-T, ST 10Base-FL
w Isolation: 10Base-T: Transformer isolated. Min.
isolation voltage: 1500 VAC RMS/2250 VDC
10Base-FL: Optical
w Protocols: TCP/IP, Telnet, ION, Modbus RTU
Internal Modem
w Data Rate: 300 bps-33.6 kbps (V.34, V.32 bis, V.32,
V.22 bis, V.22 A/B, V.23, V.21, Bell 212A, Bell 103)
Automatic data rate detection is supported
w Error Correction: V.42 LAPM, MNP 2-4, MNP 10
w Data Compression: V.42 bis/MNP 5
w Interface: RJ11 (Tip & Ring)
w Governmental Approvals: FCC Modem: FCC P68
(USA), Industry Canada CS-03 (CAN)
w CE Modem: CTR21 (Austria, Belgium, Denmark,
Finland, France, Germany, Greece, Iceland,
Ireland, Italy, Luxemburg, Netherlands, Norway,
Portugal, Spain, Sweden, Switzerland, UK)
Environmental Conditions
w Operating Temp:-20 to +70 C (no formation of ice)
(-4°F to 158°F)
w Storage: -40 to +85 C (-4°F to 185°F)
w Humidity: 5 to 95% non-condensing
Shipping
w 7.1 lbs / 3.2 kg
w 17 x 10 x 11 inches (0.98 cu. ft.)
40.8 x 24 x 27.9 cm (0.0235 cu. m)
Display
w Type: FSTN Liquid Crystal Display (LCD)
w Resolution: 320 x 240 pixels (1/4 VGA)
w Temperature: Display operational -20 to +60 C
w Backlight: Cold Cathode Fluorescent (CCFT)
Standards Compliance
IEC687 Compliance: *
w Complies with IEC687 S0.2
ANSI Compliance: *
w Complies with ANSI C12.20 CA0.2
* Products meet or exceed the accuracy requirements
of the standards listed. All products tested internally by
Power Measurement. Some products tested by third-
party laboratory. Due to form factor of some meters,
not all ANSI/IEC compliance tests may apply. Contact
Power Measurement for further clarification.
Safety/Construction
w IEC1010-1 (EN61010-1) Safety requirements for
electrical equipment for measurement, control and
laboratory use
w CSA C22.2 No 1010-1 Canadian Standards
Association
w UL3111-1 Measuring, Testing and Signal
Generation Equipment
Electromagnetic Immunity
w IEEE C.37-90.1-1989 IEEE Standard Surge
Withstand Capability (SWC) Tests for Protective
Relays and Relay Systems (ANSI) (All inputs
except for the network communication port)
w IEC1000-4-2 (EN61000-4-2/IEC801-2)
Electrostatic Discharge (B)
w IEC1000-4-3 (EN61000-4-3/IEC801-3)
Radiated EM Field Immunity (A)
w IEC1000-4-4 (EN61000-4-4/IEC801-4)
Electric Fast Transient (B)
w IEC1000-4-5 (EN61000-4-5/IEC801-5) Surge
Immunity (B)
w IEC1000-4-6 (EN61000-4-6/IEC801-6)
Conducted Immunity
w ANSI C62.41 Surge Immunity
w IEC1000-3-2 (EN61000-3-2) Limits for harmonic
currents emissions (equipment input current < 16
amps per phase).
w IEC1000-3-3 (EN61000-3-3) Limitation of voltage
fluctuations and flicker in low voltage supply
systems for equipment with rated current < 16
amps.
w ENV51040 Radiated EM Field Immunity (A)
w ENV51041Conducted EM Field Immunity (A)
w EN50082-2 Electromagnetic Compatibility,
immunity
Electromagnetic Emission
w FCC Part 15 Subpart B, Class A Digital Device,
Radiated Emissions2
w EN55011 (CISPR 11)
Radiated/Conducted Emissions2 (Group 1, Class
A)
w EN55022 (CISPR 22)
Radiated/Conducted Emissions (Class A)
w EN50081-2
Electromagnetic Compatibility, emissions2
Electromagnetic Emission
w FCC Part 15 Subpart B, Class A Class A Digital
Device, Radiated Emissions
w EN55011 (CISPR 11) Radiated/Conducted
Emissions(Group 1, Class A)
w EN55022 (CISPR 22)
Radiated/Conducted Emissions (Class A)
w EN50081-2 Electromagnetic Compatibility,
emissions
Markings
Miscellaneous
Quality Assurance: ISO 9002-1994
Warranty
3 years parts and labor
7
7600 ION/7500 ION
ISO 9002-94
Registration Cert# 002188
Comentários a estes Manuais