
22
7-
AUX 1: Controls the
VIOLET/BLACK
AUX 1 output activation type and timing.
Push and Hold
- Output
is
continuously active
until
transmitter button is
released.
Latched - Output stays active
until
button is pressed again.
Latched
until IGN ON
-Output
stays active
until
the ignition is turned on.
Dome Light Output - Output used for
illuminated
entry and is not
controlled
by the AUX 1 function of the transmitter.
Defrost Output
Single Pulse
- Single 1 second
pulse
after start
Defrost Output Latched 5 Minutes -
5 minute continuous output after
remote start.
Feature Bank
4-
Remote
Start Control
1 - RF
Start
Chirp: Turns remote start activation confirmation chirps
ON or
OFF.
2 - Run Time: Controls the time
in
minutes that the vehicle
will
stay running
under control of the remote start
until
the system times out. The system may
also
be shut down at any time by use of the transmitter or system shutdowns.
3-
Running Lights: Controls the
WHITE parking light output wire during remote
start.
Steady - Parking
lights
constant during the remote start cycle.
Flashing - Parking lights flash at a slow pace during the remote start cycle.
4
- Tach Mode: Determines how the system monitors the engine running during
remote start.
Tach - Hard wired directly to the tach wire of the
vehicle
to monitor AC
voltage.
Tachless (Crank AverageNoltage) - Determines crank time by averaging the
last 8 times the vehicle was started with the key and then monitors the
change
in
voltage after remote start.
Hybrid (Crank Average
I No Voltage) - Determines crank time by averaging
the
last
8 times the vehicle was started with the
key.
OBI
Port - Monitors the vehicle's tach rate through
an
interface module
connected to the
OBI
port.
ca5553sst
rev
A
Comentários a estes Manuais