Code Alarm ca5553sst Manual do Utilizador descarregar pdf (Página 15)

Additional Ports

Antenna I LED I Programming Port

Mount the supplied antenna/receiver to a clear spot

the vehicle's windshield

that will not block the driver's vision. A good location is usually high

the

windshield near the rear view mirror.

careful not to mount the antenna/receiver

on any metallic window film, as this will effect system range. Route the antenna/

receiver cable to the control module and plug into the antenna port.

Data Bus Interface Port

This 4 pin port is used for Flashlogic Door Lock and Transponder Databus

Interfaces to communicate with the vehicle's Databus. When using the

OBI

port to

control the Flashlogic Door Lock and Transponder Interface modules the

following options may

available. Please refer to the

020

(Data to Data)

function list available per vehicle

the tech service web site.

Tach

Input Brake Safety Shut Down

Trunk/Hatch Open Diesel Glow Plug Input

Door Lock Control Passlock I Passkey Interface (GM Only)

Dome Light Supervision Transponder Interface Activation

Factory Alarm Arm

I Disarm Manual Arm I Disarm Inputs (factory keyless

controls system)

Telematic Interface Port

This 4 pin port is used for Telematic Interface accessories, such as Carlink,

which can control some of the following features.

Door Lock Control Trunk Release

Sliding Doors AUX Output

Car Find Remote Start

2012 Audiovox Electronics Corporation.

All

rights reserved. 1 5

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 48 49

Sem comentários

Code Alarm ca5553sst Manual do Utilizador Página 15