6
Using the Remote Start feature
Starting Your Vehicle
The remote start function is activated by pressing and holding the
START button for 2 seconds on the remote control. The system will
check the vehicle to ensure that it is safe to start, and if all safety
parameters are correct, the engine will start within 5 seconds (diesel
engines will take longer.) Press and hold the START button again to
turn off the vehicle. While in Remote Start mode, the vehicle parking
lights will remain ON. The vehicle will run for 12 or 25 minutes,
depending on run time selected by your installer.
If your vehicle stalls after Remote Start...
If the vehicle stalls or does not start, the Code Alarm CA-530
TM
will
pause for 5 seconds, then try 3 more times to start the vehicle (a total
of four attempts). The system pauses 5 seconds between each start
attempt. If the vehicle does not start after the fourth attempt, the
Code Alarm CA-530
TM
will abort the start process. See Remote Start
Safety Features on the following page for additional no start
conditions.
Your vehicle can be started by remote control whether the vehicle is
locked or unlocked.
Entering the Vehicle While It is Running via Remote Start
1.Press UNLOCK to unlock the door(s) and turn off the starter
disable (if it is not already off).
2.Enter the vehicle. Do not press the brake pedal.
3.Insert the key into the ignition and turn to the ON position.
4.Press the brake pedal. The remote starter disengages and the
vehicle will operate normally.
Remote Start / Stop Feature
Press and hold the START button on the remote control.
If all safety parameters are correct, the engine will start within 5 seconds
(diesel engines will take longer.) Press and hold START again to turn
off the vehicle. (Turn to page 6 for more on remote start features.)
Valet/Service Mode
You can turn off all remote start functions and prevent the starter
disable by engaging the Valet/Service Mode:
• To engage Valet mode, turn the ignition key to the ON position
(last position before start) and press the LOCK and UNLOCK
buttons on the remote control simultaneouly. If installed, the blue
status light will blink to indicate Valet mode
• To disengage Valet mode, turn the ignition key to the ON
position (last position before start) and press the LOCK and
UNLOCK buttons on the remote control simultaneouly. If
installed, the blue status light will stop blinking to indicate Valet
mode has been terminated.
CA 530 owners rev 7-04.pmd 7/18/2004, 3:15 AM6
(10 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais