Code Alarm CR3 Manual do Utilizador descarregar pdf (Página 47)

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx

2011-04-27 Page 47 of 65

•

14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065

•

(801) 495-2200

•

FAX (801) 495-0280

Name

Comments

# bytes

Auto Connect

If connection information exists for the specified

Device Address, use it to establish a connection.

Otherwise, attempt to establish a connection and

store the resulting information.

Clear Setup

Remove connection information associated with the

specified Bluetooth

Address.

Send Setup

Print all connection information in the following

format

iiii xxxxxxxxxxxx p

Where iiii is the storage index, xxxxxxxxxxxx is

the Bluetooth

Device Address, and p indicates

pairing enabled (y) or pairing disabled (n).

Get Bluetooth

Address

Get Bluetooth

address as 12 Hexadecimal

characters

Get “user

friendly” name

Get device’s “user friendly” name

10 Code Reader Batch (CRB) System

The Code Reader Batch (CRB) system is a convenient method for creating and maintaining a set of

commands that can be easily sent to the Reader. These CRB files can be created in any text editor with

the file extension of .crb. The CRB system accepts all of the valid text commands. The most commonly

used commands are J, N, P, and ~. There should be one command per line. The CRB file may contain

empty lines and comments as well.

The .crb files can be sent to the Reader using either the USB or RS232 downloader’s. As CRB files are

just a list of text commands, they can also be sent by a serial terminal program. Note: if using a serial

terminal program the Reader will first need to be commanded in to “text command mode”; see

Section 6.1.

You can request a copy of all the CR2 User Manual configuration codes in the .crb format. For example,

code M121_01 in the manual (setting the Bluetooth

radio timeout to 5 minutes) is the following:

File M121_01.crb:

P%9f#300

The CRB system allows for combining multiple functions into a single file. For example, you can create

a test.crb file that contains commands to set the left trigger to B3 (M030_01), enable ALL RSS codes

(M267_01), disable auto-transfer of buffer memory (M069_01), and make the Reader beep three times.

Note you can also comment your CRB file with a semicolon (;) as shown below. A comment starts with

a semicolon character and lasts till the end of the line. The ;>PAx sequence has special meaning. See

Section 6.1.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 64 65

Comentários a estes Manuais

Sem comentários

Code Alarm CR3 Manual do Utilizador Página 47

Comentários a estes Manuais